CSL Elbe

CSL Elbe

CSL Elbe

On April 6, the 118 meter long, 10,110 dwt bulk carrier CSL Elbe allided with the pier at Stade-Bützfleth, Germany.  The bulk carrier had arrived from Rafnes and was attempting to maneuver to its berth when the port-side stern struck the pier. The bulk carrier along with the pier sustained damage. The water police launched an investigation into the incident. Reports state there was a pilot on board and tugs were assisting at the bow and stern.  The CSL Elbe was allowed to depart the port bound for Jossingfjord on April 8th. No reports of injuries or pollution released.

CSL Elbe

Cap Jean

Cap Jean

Cap Jean
Photo: francetvinfo.fr

The 12 meter long fishing vessel Cap Jean ran aground off Cape de Miquelon, Saint Pierre, France. The fishing vessel requested assistance with a pilot boat, a SNSM lifeboat and the French Navy vessel Fulmar responding. The vessels found the Cap Jean resting on a sandbank and would remain aground until the rising tide. Several hours later at high tide, the pilot boat pulled the Cap Jean free then towed the fishing vessel to Miquelon. No reports of injuries to the 7 crew, damage or pollution released.

Milano Bridge

Milano Bridge

Milano Bridge
Photo: seanews.com.tr

The 366 meter long, 146,931 dwt container ship Milano Bridge allided with a quay at Busan, South Korea. The boxship had arrived from Shanghai and was maneuvering to a berth at the north terminal when the port hull collided with the quay and several container cranes. One crane (designated as no. 85) was struck hard enough to cause it to collapse. The crane operator on board was able to jump free while still 30 feet in the air. He sustained minor injuries and was later taken to hospital.

Another crane (no. 81) suffered major damage, but didn’t collapse.  Crane (no. 84) was pushed off its tracks and Cranes (no. 82 and 83) did not suffered any major damage. The Milano Bridge also sustained damage to its bridge, port side hull, railings and deck plating buckled. Parts of the crane (no. 85) fell onto the vessel while other portions fell into the water. No reports of pollution released.  Reports state it may take up to 18 months to replace gantry crane (no. 85) and 5 months for Crane (no. 84) to be repaired.  Busan Coast Guard has launched an investigation into the incident.

Timeline:

14:37: Commenced Starboard turn, STBD 20 Helm, Dead Slow Ahead, Speed: 9.3 Knots
14:39: Stopped engine, Speed: 7.6 Knots
14:40: Pilot appeared panicked, Speed 7.6 Knots, Dead slow ahead Starboard 20 helm.
14:42: Pilot realizes heavy drift to port, panicked, full ahead engine, hard Starboard helm, concerned to avoid three (3) moored vessels. AFT Tug continuously pulling.

14:44: Cleared 1st moored vessel, drifting towards 2nd moored vessel, Navigation full ahead, Starboard 20 helm, drifting further towards berth. FWD tug’s action not known as pilot speaking in local language. Master used BT.
14:47: Cleared 2nd moored vessel, random orders on ME and rudder, stern drifting towards port side, Speed 6 Knots. 14:47: Cleared lesser beamed 3rd moored vessel.

14:49: Made hard contact with Gantry no.85 , fully collapsed on stern of ONE vessel. ME Nav full ahead, speed. 5.2 Knots. FWD tug not pulling.
14:50: Emergency full stern to prevent contact with moored vessel ahead.
14:52: Hard contact with Gantry crane no. 81 by bridge wing, which was working on the moored container vessel ahead followed by slight contact with the moored vessel around Bay 02 & 06.